12
Getting Started
2.5 Registration (Pairing)
The Baby Monitor is pre-registered to your Parent Unit. You do not
need to register it again unless the Baby Unit loses its link with the
Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedures below:
1. Press the
M
button and the menu bar will pop up.
2. Press the
<
LEFT button or
>
RIGHT button until is highlighted,
and the
del/ add/
view/
scan menu will pop up.
3. Press the
+
UP button or
-
DOWN button to select add, and
press the
O
button to confirm.
4. Camera
/ / / will pop up. Press the
+
UP button or
-
DOWN button to select the desired Camera, and press the
O
button to start searching for a camera unit.
Note: If a camera is currently paired with the Parent Unit, its
camera location (with a * against it) cannot be selected for a new
registration.
5. Press and hold the PAIR button on the underside of the Baby
Unit until the Parent Unit finds the camera, beeps and PAIR OK
appears on the screen. The video from the camera will then
appear.
NOTE
A camera can only be registered to one Parent Unit at any one time.
To Next Page
Loading...
Need help?
General
