3.6
Removing the Universal Connector Cover
Procedure:
1 Remove the universal connector cover or dust cover by pulling the cover out.
CAUTION: Close the dust cover when the universal connector is not in use.
3.7
Turning the Radio On
Procedure:
Rotate the On/Off/Volume Control knob clockwise to turn on the radio.
If successful, your radio shows the following indications:
• A tone sounds.
NOTICE: If the Tones/Alerts function is disabled, there is no tone upon powering up.
•
Postrequisites:If your radio does not power up, check your battery. Make sure that the battery is
charged and properly attached. Contact your dealer if your radio still does not power up.
3.8
Turning the Radio Off
Procedure:
Rotate the On/Off/Volume Control knob anti clockwise to turn off the radio.
3.9
Adjusting the Volume
Procedure:
Turn the Volume knob to adjust the volume of the radio.
MN007472A01-AA
Chapter
3: Getting Started
14