10 Getting Started
4. If there is not a connection or you are out of range, the video display will go
off, the symbol will flash on the LCD display, and the unit will beep
every 9 seconds. (If the unit is on scan the
1 ?
symbol displays.)
Move the Parent Unit closer to the Baby Unit the link is re-established.
5. Press and hold the
P POWER ON/OFF button, until the progress bar
scrolls fully across, to turn OFF the Parent Unit.
NOTE
The battery icon will turn RED, flash, and beep approximately every 5
seconds to indicate the battery is low and needs to be recharged. The battery
pack will take approximately 16 hours to charge.
When charging
1. If the Parent Unit is turned OFF, when the adapter is plugged in, it displays
a "mains plug" icon briefly, then a large battery icon with internal segments
cycling for 60 seconds, before the display goes blank. Note, the unit
continues to charge. The Blue LED at top left corner will light up to indicate
the adapter is plugged in.
2. If the Parent Unit is turned ON, when the adapter is plugged in, the battery
icon in the screen's top right corner will show that the battery is charging by
cycling the internal segments. The segments stop cycling when the battery
is fully charged. The Blue LED at top left corner will light up to indicate the
adapter is plugged in.
To Next Page
Loading...
Need help?
General
