16 Parent Unit Menu Options
4.5.3 Delete a camera
1. Press the button.
2. Press the
- DOWN button to select the Camera setting icon , and
press the
button to enter. Press the - DOWN button to select DELETE
CAMERA icon and press the
button to confirm.
3.
1
/
2
/
3
/
4
will pop up, press the + UP button or - DOWN button to
select the desired Camera unit, press the
button then press the -
DOWN button to select the DELETE CAM icon .
4. Press the
button to confirm the deletion or RETURN button to exit.
NOTE
You cannot delete the camera if it is the only camera paired in the system.
4.5.4 Scan the cameras
1. Press the button.
2. Press the
- DOWN button to select the Camera setting icon , and
press the
button to enter. Press the - DOWN button to select and
choose the symbol for scan selection.
3. The screen will then display images from each registered camera in a loop,
changing about every 10 seconds.
TIP
Quick Method to View Cameras instead of using the menu.
Directly press repeatedly to select
1
/
2
/
3
/
4
or .
NOTE
If the Parent Unit is in scan mode and one of the registered cameras is turned off
or out of range, the scan will stop at the missing camera
(e.g. camera) and display the
3 ?
icon while emitting a warning beep every
8 seconds.
WARNING
Check the camera and correct the fault immediately if you are using that
camera to monitor your baby.
If you want to continue in camera scan mode without that camera, delete the
camera (see 4.5.3 Delete a camera) and start the scan again.
To Next Page
Loading...
Need help?
General
