Help 21
ENGLISH
Interference
Noise interference on your Parent Unit
• Your Baby and Parent Unit may be too close. Move them farther apart.
• Make sure there is at least 1 to 1.5 metres (3 to 4.5 feet) between the 2 units to
avoid audio feedback.
• lf the Baby Unit is too far away it may be out of range, try moving the Baby
Unit closer to the Parent Unit.
• Make sure the Baby and Parent Unit are not near other electrical equipment,
such as a television, computer or cordless/mobile telephone.
• Use of other 2.4 GHz products, such as wireless networks (Wi-Fi
®
routers),
Bluetooth
®
systems, or microwave ovens, may cause interference with this
product, so keep the Baby Monitor away at least 1 to 1.5 metres (3 to 4.5 feet)
away from these types of products, or turn them off if they appear to be
causing interference.
• If the signal is weak, try moving the Parent and/or Baby Unit to different
positions in the rooms.
Reasons of Measurement Error
• Dirty probe tip
Please refer to the cleaning process in the manual to make sure the
cleanliness of probe tip.
• Unstable human status, such as: hot or cold baths, physical exercise,
smoking and or drinking hot and cold beverages, etc.
Please avoid exercise, bathing for 30 minutes prior, keep the forehead clean
and dry before measurement.
• Unstable environment, such as: the vent of air conditioning or fan.
Make sure the thermometer has been at room temperature for 15 minutes
before use.
• Wrong measurement area
Users should measure the correct position as Fig. 1 shown on page 13.
• Wrong measurement way
When scanning, the probe should face the midde of the forehead area & the
measurement distance should be as close as possible.
To Next Page
Loading...
Need help?
General
