Getting Started 13
ENGLISH
2.4 Registration (Pairing)
The Baby monitor is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1. Press the
M button of the parent unit and the menu bar will pop up.
2. Press the
< LEFT button or > RIGHT button until is highlighted, and
then press the
O button so the
Add
/
Delete
menu will pop up.
3. Press the
+ UP button or - DOWN button to select
Add
, and press the
O button to confirm.
4.
cam 1
/
cam 2
/
cam 3
/
cam 4
will pop up, press the + UP button
or
- DOWN button to select the desired Camera and press the O
button to start searching for a camera unit. The green ON / OFF LED will
flash rapidly while searching.
5. Press and hold the PAIR button underneath the baby unit until the parent
unit finds the camera and beeps. After a short delay the video from the
camera appears.
NOTE:
You can only register a new camera to a camera number that is not already
paired.
Paired camera numbers are indicated by a *, such as cam*1.
If the camera being paired was registered previously, it will lose the old
registration when it is paired again
To Next Page
Loading...
