Motorola MBP36S - Parent Unit Power Supply

Getting Started 11
ENGLISH
2.3 Parent Unit Power Supply
IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended, to allow temporary operation of the parent unit in the event of
a power failure or if the parent unit is moved.
1. Connect the small plug of the power adapter to the parent unit and the
other end to the electrical outlet. Only use the enclosed power adapter (6V
DC / 600mA) with the slightly smaller DC plug.
2. Press and hold the
P POWER ON/OFF button to turn ON the parent
unit.
3. Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit.
4. If there is no connection or you are out of range, the video display will
change to the Motorola screen with a flashing icon and the unit will
beep about every 10 seconds. Move the parent unit closer to the baby unit
until the link is re-established.
5. Press and hold the
P POWER ON/OFF button to turn OFF the parent
unit.
NOTE
The battery icon turns RED, the Power Indicator LED flashes RED and the
unit emits a beep about every 10 seconds to indicate that the battery is low and
needs to be recharged. The battery pack takes about 16 hours to charge fully.