Motorola MBP88CONNECT - Page 3

3. Pairing Your Camera Unit with a Parent Unit
The unit works as an accessory camera with Motorola models: MBP88CONNECT
To re-register your Camera Unit (Baby Unit), or register a new Camera Unit (Baby Unit), follow the
procedures below:
1. Press the
M button of the Parent Unit and the menu bar will pop up.
2. Press the
< LEFT button or > RIGHT button until
is highlighted, and the del/ add/
view/ scan menu will pop up.
3. Press the
+ UP button or - DOWN button to select add , and press the O button to
confirm.
4. Camera
will pop up, press the + UP button or - DOWN button to select the
desired Camera, and press the
O button to start searching for a camera unit, with "press PAIR
on cam" shown.
Note: If a camera is currently paired with the Parent Unit, its camera location (with a * against
it) cannot be selected for a new registration.
5. Press and hold the PAIR button on the underside of the Baby Unit until the Parent Unit finds the
camera, beeps and PAIR OK appears on the screen. The video from the camera will then
appear.
NOTE
A camera can only be registered to one Parent Unit at any one time.
/ / /