Run the Setup Wizard
When you log into the MD1600 for the first time, the Configure
my Internet Connection screen appears. If you want the
MD1600 to detect your DSL connection, select your Country
and Internet service provider from the drop-down list and click
Next. If you want to manually configure the MD1600, select No,
I want to configure the Internet connection myself and click
Next. To learn how to configure the Internet connection
yourself, skip ahead to Configuring your Connection
Manually, below.
The wizard will now try to configure your Internet connection.
If it determines that you need a Username and Password to set
up your connection, it will prompt you for your Username and
Password. Enter your Username and Password, and then click
Next. Your Username and Password are case-sensitive. Click
Save on the Internet Connection screen to save your
configuration.
Your DSL Username and Password are different from the
Username and Password you may use for email and the
Username and Password used to log into the MD1600. If you
need to ask your service provider for your Username and
Password, make sure the service provider knows that you need
your DSL login information.
If your DSL connection does not need a Username and
Password, the Congratulations screen appears. Click Next and
then Save on the Internet Connection screen to save your
configuration.
Now try going to a website to check that your connection is
working. If it is, Congratulations! You may start using your
MD1600, or you can learn how to connect additional devices to
the MD1600 as described in the Connect Your Devices section
below. If you can’t access the website, please see the
troubleshooting section at the end of the manual.
If the MD1600 does not detect your connection, you can press
Back to try again or click Next to configure it manually.
Configuring your connection manually is described next.
To Next Page
Loading...
Need help?
General