4
LET’S GET STARTED
1. Turn o and disconnect any existing modems or routers on your network.
2. Connect coax cable that has active cable service to the modem’s
COAX connector. Ensure that you have access to the bottom label
during setup and activation of the modem.
3. Plug the MG8725 into a power outlet using the power adapter.
4. Wait for the online light ( for 3.0, or for 3.1) to stop flashing
and remain on for at least 1 minute. This process may take up to 15
minutes and the modem may reboot multiple times.
Note: You may use a coax splitter to share the cable connectivity with your
TV. Use a two-way splitter with a top frequency of 1,000 MHz or higher.
Please note this may reduce the device’s performance.
To Next Page
Loading...
