English
6
Using the Volume/Channel Knob
The Volume/Channel Knob can be programmed as dual
purpose for both volume and channel or as a volume-only
control.
To adjust volume, see Adjusting the Volume on page 5.
To change channels, push and hold the knob until channel
selection screen is displayed, then turn the knob to the
required channel.
To exit channel selection state, do any of the following.
• Push the Volume/Channel Knob again.
• Press g
• Press e
• Wait for the menu timer to expire
Accessing the Radio from Password
1. Power up the radio.
2. You hear a continuous tone.
3. Enter your current four-digit password via keypad
microphone.
The display shows ●●●●. Press g to proceed.
OR
Enter your current four-digit password. Press f or h
to edit each digit’s numeric value and g to enter the
selected digit and move to the next digit. Each digit
changes to ●. Press g to confirm your selection.
You hear a positive indicator tone for every digit
pressed. Press < to remove the each ● on the display.
You hear a negative indicator tone, if you press < when
the line is empty, or if you press more than four digits.
4. If the password is correct:
Your radio proceeds to power up. See Powering Up and
Turning Off the Radio on page 5.
OR
If the password is incorrect:
The display shows Wrong Password. Repeat Step 3.
OR
After the third incorrect password, the display shows
Wrong Password and then, shows Radio Locked. A
tone sounds and the LED double blinks yellow.
To Next Page
Loading...
