Let’s get started
First connect the MR2600’s yellow Ethernet cable between
the MR2600’s WAN port and the Ethernet port of a cable
modem, DSL modem, fiber optic modem, or an in-building
Ethernet network used for Internet access.
If you are using a modem, switch the power of the modem off
now. (For some modem/routers, this requires you to remove
a power backup battery.) After the modem is off for at least
10 seconds, switch it back on. (If you removed a backup
battery, plug the battery back in first.)
AC power
outlet
Ethernet port of
modem or in-
building network
To Next Page
Loading...
