•
The extension cord is properly wired and in good condition.
•
The extension cord size is 18 AWG for lengths up to 100
f
eet, and 16 AWG for lengths up to 150 feet.
9
. The supply cord of the AC adaptor cannot be replaced.
I
f the cord is damaged, call customer service at
1-800-448-6686 (U.S. and Canada) or e-mail us at
consumerradio@motorolasolutions.com..
2
MR350/351
For a fax:
Contact the
Fax-0n-Demand
system
For mail service:
Call the FCC
Forms Hotline
If you have
questions about
the FCC License:
Call the FCC
1-202-418-0177 1-800-418-FORM
(3676)
1-888-CALL-FCC
(225-5322)
Getting Started
I
nstalling the Batteries
E
ach radio can use either 1 NiMH rechargeable battery pack or
3
AA alkaline batteries and beeps when the batteries are low.
I
nstalling NiMH Rechargeable Battery Pack (Optional
Accessory)
1. Turn the radio off.
2. With the back of the radio facing you, lift the battery cover
latch up and remove the cover.
3. Remove the NiMH battery pack from the clear plastic bag
(do not disassemble or unwrap the battery pack).
4. Insert the NiMH battery pack with the diagram facing you.
(The ribbon should be underneath the battery pack and
should wrap around the right side of the pack for easy
r
emoval.)
5. Reposition the battery cover and press down to secure.
Installing the Three AA Alkaline Batteries
1
. Turn the radio off.
2. With the back of the radio facing you, lift the battery cover
latch up and remove the cover.
3. Insert the three AA alkaline batteries with + and - polarity as
shown inside. (The ribbon should be underneath the AA
a
lkaline batteries and should wrap around the right side of
the batteries.)
4. Reposition the battery cover and press down to secure.
Radio Battery Meter
The radio battery icon shows the battery charge level, from full
to empty . When the radio has one segment left, the
radio chirps periodically or after releasing (Low Battery Alert).
Removing the NiMH Battery Pack (Optional Accessory)
1. Turn the radio off.
2. With the back of the radio facing you, lift the battery latch up
to release the battery cover and remove the cover.
3. Remove the NiMH battery pack by pulling the ribbon
attached to the radio.
4. Reposition the battery cover and press down to secure.
Removing the Three AA Alkaline Batteries
1. Turn the radio off.
2. With the back of the radio facing you, lift the battery latch up
to release the battery cover and remove the cover.
3. Gently remove each alkaline battery by easing each battery
out individually.
4. Reposition the battery cover and press down to secure.
Notes
• Exercise care when removing NiMH or AA batteries. Do not
use sharp or conductive tools to remove either of these
batteries.
• Remove the batteries before storing your radio for extended
periods of time. Batteries corrode over time and may cause
permanent damage to your radio.
Using the Battery Charger (Optional Accessory)
The battery charger provides drop-in charging convenience for
NiMH batteries and can be placed on any flat surface, such as a
desk or workbench. Charge the NiMH battery overnight (at least
16 hours) before using it for the first time. After the initial charge,
an empty battery is fully charged within 14 hours.
1. Follow the steps above to install a NiMH Battery Pack.
2. Plug the AC power supply cord into the jack on the desk
stand.
3. Plug the AC power supply into a standard wall outlet.
4
. With a radio facing forward, slide it into one of the charging
p
ockets.
5
. When charging in the battery charger, the red light on the
charger base will glow continuously.
U
sing the micro-USB Charging Connector
T
he micro-USB charging connector is a handy port that allows
y
ou to conveniently charge the NiMH battery pack. If using a
c
omputer, the computer must be turned on.
1
. Plug the micro-USB cable or charger into a power source as
is appropriate for your accessory.
2
. Plug the cable into the micro-USB port on the bottom of the
radio.
3
. An empty battery will be fully charged in 14 hours.
4
. The battery icon will scroll as the battery is being charged.
T
he scrolling icon will stop when the battery is fully charged.
N
otes
•
When moving between hot and cold temperatures, do not
c
harge the NiMH battery pack until the battery temperature
a
cclimates (usually about 20 minutes).
•
For optimal battery life, remove the radio from the charger
within 16 hours. Do not store the radio while connected to the
charger.
•
If the radio is kept on while charging, the charging time will
be extended.
•
Even though the charger is connected, you may not be
a
ble to transmit a message if the battery is completely
empty . Allow time for the battery to charge to 1 bar
before attempting to transmit a message.
Attaching and Removing the Belt Clip
1. Attach belt clip to pocket or belt strap.
2
. Align the belt clip post with the hole in the back of the radio.
3
. Gently push until the clip clicks in place.
T
o Remove
1
. Push down on the release tab at the top of the belt clip to
release the catch.
2. Pull the belt clip away from the back of the radio.
Turning your Radio On and Off
Turn clockwise to turn the radio on and counterclockwise to
turn the radio off.
1. In the ON position, the radio chirps and briefly shows all
feature icons available on the radio.
2. The display screen then shows the current channel, code
and all features that are enabled.
Setting the Volume
Press and hold for three seconds while rotating until you
reach a comfortable listening level.
1. Rotate clockwise to increase the volume.
2. Rotate counterclockwise to decrease the volume.
Do not hold the radio close to your ear. If the volume is set to an
uncomfortable level, it could hurt your ear.
ing and Listening
Talking and Listening
To communicate, all radios in your group must be set to the
same channel and Interference Eliminator Code.
1. To talk, press and hold .
2. When you are finished talking, release .
For maximum clarity, hold the radio two to three inches away
from your mouth and speak directly into the microphone. Do not
cover the microphone while talking.
FCC Licensing Information
Your Motorola radio operate s on General Mobile Radio Service
(GMRS) frequencies and is subject to the Rules and Regulations
of the Federal Communications Commission (FCC). The FCC
requires that all operators using GMRS frequencies obtain a
radio license before operating their equipment. To obtain the
FCC forms, please visit the FCC’s Web site at
wireless.fcc.gov/uls/index.htm?job=home to source form 605
and 159, which includes all the instructions you will need.
If you wish to have the document faxed or mailed, or if you have
questions, please use the following contact information:
C
hanges or modifications not expressly approved by Motorola
m
ay void the user’s authority granted by the FCC to operate this
radio and should not be made. To comply with FCC requirements,
transmitter adjustments should be made only by or under the
s
upervision of a person certified as technically qualified to
p
erform transmitter maintenance and repairs in the private land
m
obile and fixed services as certified by an organization
r
epresentative of the user of those services. Replacement of any
transmitter component (crystal, semiconductor, etc.) not
authorized by the FCC equipment authorization for this radio
could violate FCC rules.
Display Screen Guide
Numbers for Channel,
Call Tone
Numbers for Codes
To Next Page
Loading...
