46 MTM800 Enhanced Mobile Terminal Installation Manual INSTALLATION
Figure 17 Motorcycle Installation
Installing the Motorcycle Mount Enhanced Control Head
1. Slide the Motorcycle Mount Enhanced Control Head onto the mounting trunnion until it snaps
into place.
2. Tighten the screws at both sides of the trunnion. After a few turns, tilt the Motorcycle Mount
Enhanced Control Head for an optimum view of the display. Then, complete the tightening of
the screws.
3. There are two ways to mount the motorcycle trunnion, each limited to a 77 degree of
allowable movement, as shown in Figure 18 and Figure 19:
If an additional GPS antenna or a combined TETRA/GPS
antenna is used, the antenna housing carries the GPS
receiver. Take care not to cover the antenna housing with
metal or other radio wave absorbing material.
TRANSCEIVER
LOUDSPEAKER
FIST MICROPHONE
MOTORCYCLE BOX
ANTENNA
BATTERY
FUSE
BLOCK
IGNITION SENSE CABLE
P/N: HKN9327 (3m, FUSE 4A)
CHASSIS GROUND
FUSED POWER CABLE
P/N: GKN6270 (3m, FUSE 10A)
MOTOCYCLE MOUNT ENHANCED CONTROL HEAD
TRANSCEIVER-TO-CONTROL HEAD CABLE
P/N: PMKN4030
FIST MICROPHONE CABLE
P/N: GMKN4072
To Next Page
Loading...
