Radio to radio only
The radio initiates calls only on a talkgroup directly and not through a gateway or repeater.
Specific gateway
The radio can initiate calls on a talkgroup directly or through a specific gateway address that is specified for a
talkgroup. The gateway address can be edited through the radio MMI.
Auto gateway
The radio can initiate calls on the selected talkgroup directly with another radio or through any available gateway
that is detected as present.
Repeater
The talkgroup links to a DMO repeater.
Specific gateway and repeater
The radio uses only the gateway with the specified gateway address for the talkgroup and/or a DMO repeater.
Automatic gateway and repeater
The radio uses the first available gateway for a talkgroup and/or a DMO repeater. If either specific gateway or auto
gateway mode is chosen, and a suitable gateway is found, all outgoing calls are placed through the gateway. If a
suitable gateway is not found, or a call setup through the gateway fails, the radio attempts to set up the call directly.
When operating on a gateway and/or repeater, the radio indicates the communication mode.
Standard Home Group
The standard home group feature enables configuring of the default talkgroup to be selected when the radio switches
operation modes from: TMO –> DMO and TMO –> Repeater, or when powering up.
Communication through Repeaters
Radios that are out of range and cannot communicate directly one with another in DMO Mode can do it through the
repeater. The repeater is a radio that repeats all communication on a chosen channel, and as a result increases radios’
DMO range.
When the radio connects to a repeater, it plays a tone, displays the Repeater available message, and shows an
appropriate icon. When the radio looses connection with the repeater, it plays a tone, displays the Repeater not
available message, and the repeater icon is blinking.
64 | Services and Features
Send Feedback | | 68015000878-G
To Next Page
Loading...
