Table 16: Status Icons
Icon Description
Trunked Mode Operation
In Service
No Service
Signal Strength – The more bars, the stronger the signal.
RF Power — Indicates the High RF Power is enabled. Shows the signal strength. The more
bars, the stronger the signal.
Migration — Displayed when your radio is registered to the foreign network.
Broadcast Call — Displayed when the radio is in the Broadcast Call.
Scan — Indicates talkgroup scanning is activated in the radio.
Data Connected — Displayed when the data connection is idle (standby).
Data Transmit/Receive — Displayed when the data connection is active. Number 1, 2, 3, or
4 indicates how much bandwidth is used during transmission (25%, 50%, 75%, or 100%).
Direct Mode Operation
Direct Mode Call — Displayed when the radio is receiving a Direct Mode call. The more
bars, the stronger the signal.
or
High RF Power: idle or transmitting — Displayed when the High RF Power option is ena-
bled and the radio is either in the idle mode or transmitting a call.
High RF Power: receiving — Displayed when the High RF Power option is enabled and the
radio is receiving a call.
Direct Mode — Displayed when the radio is in Direct Mode (radio-to-radio communica-
tion).
Repeater Mode — Displayed when the radio is switched to work as a repeater in Repeater
Mode.
DMO Gateway Communication Mode — Indicates that gateway is selected. The icon has
the following states:
• Solid — while the radio is synchronized with the gateway.
• Blinking — while the radio is not synchronized or during attachment.
• No icon — during a radio to radio and repeater call.
DMO Repeater Communication Mode — Displayed when the Repeater or GW + Rep op-
tion in DMO Mode is selected. This icon has the following states:
• Solid — while the radio has detected the repeater (for example when the radio receives a
presence signal).
• Blinking — while the radio has not detected the repeater or during attachment.
Table continued…
82 | Man-Machine Interface
Send Feedback | | 68015000878-G
To Next Page
Loading...
