10
2. Insert the rechargeable Ni-MH battery cells supplied. Note the ’+’ and
’-’ markings inside the battery compartment and insert in the correct
direction.
3. Slide the battery cover back into place.
Important
Warning! Use only the approved rechargeable Ni-MH battery cells
(2 x AAA Ni-MH rechargeable batteries) supplied with your PIP11.
Connecting and charging the parent unit
You will need to carry out this process for the single or dual parent units.
1. Plug the DC plug of the power adaptor into the DC jack on the side of the
parent unit and plug the other end of the AC adaptor into the AC power
outlet.
2. Switch on the AC power. The parent unit turns on.
3. When charging the batteries for the first time, charge for at least 16 hours
continuously.
4. When the parent unit is fully charged, will appear steadily on the
display.
Getting started
To Next Page
Loading...
