15
3. Using the digital audio baby monitor
3.1 Turn the baby unit on / o
• Press and hold on the baby unit to turn it on. The power / linking LED
indicator will turn on.
• Press and hold on the baby unit again to turn it o. The power / linking
LED indicator will turn o.
3.2 Turn the parent unit on / o
• Press and hold on the parent unit to turn it on. The power / linking LED
indicator will turn on.
• Press and hold on the parent unit again to turn it o. The power /
linking LED indicator will turn o.
Note
If you place the parent and baby units too close together, you may hear a high
pitched noise. This is not a fault. The units are designed to be operated at
some distance apart, e.g. in separate rooms, so move the units further apart.
If the power / linking LED indicator flashes on the parent unit, they are not
linked to each other. Make sure that both units are powered on, and the
distance between the parent and baby units is less than 300 metres.
3.3 Adjust the speaker volume on the parent unit
Press the up or down key to increase or decrease the volume. There are 5
levels to choose from.
3.4 Turn the night light on or o
Press on the parent unit.
3.5 Select a lullaby for your baby
3.5.1 Play and stop the lullaby
1. Press
MENU / OK
on the parent unit.
2.
LULLABY
is displayed. Press
MENU / OK
.
3. Select
PLAY?
(if no lullaby is played) or
STOP?
(if a lullaby is being played),
then press
MENU / OK
to confirm. The selected lullaby will play back or
stop on the parent and baby units. If
PLAY ALL
has been selected (see 3.5.3
below), lullabies will play back one by one repeatedly.
3.5.2 Select a default volume level
1. Press
MENU / OK
on the parent unit.
2.
LULLABY
is displayed. Press
MENU / OK
.
3. Scroll the down key to select
VOLUME
, then press
MENU / OK
.
4. Scroll the up or down key to select a volume level, then press
MENU / OK
to
confirm.
Using the digital audio baby monitor
To Next Page
Loading...
Need help?
General
Weight and Dimensions
