Motorola PIP1500 - Camera Operations

15Using the video baby monitor
3.4 Set the timer
You can set timers on the parent unit to remind you or caregivers of the time
to feed the baby, change the baby’s diaper or put the baby to bed.
1. Press MENU on the parent unit. The status bar pops up.
2. Scroll the navigation button to .
3. Scroll the navigation button to select 2h, 4h, 6h or OFF. If the next feeding
time is 2 hours later, select 2h. When activated,
will be displayed on the
screen.
4. The parent unit will beep when the time limit is reached. Press OK to stop
the timer.
3.5 Set the temperature unit
The baby (camera) unit has a temperature sensor that can detect the baby
room temperature.
1. Press MENU on the parent unit.
2. Scroll the navigation button to .
3. Scroll the navigation button to select ° C or ° F .
3.6 Use the camera
3.6.1 Pair or add a camera with the parent unit
See 'Registering the baby (camera) unit to the parent unit (Pairing)' on
page 13.
3.6.2 Cycle cameras
1. Press MENU on the parent unit. The status bar pops up.
2. Scroll the navigation button to select .
3. Scroll the navigation button to select , then press OK.
4. If you have registered dierent cameras, the screen will display images
from dierent registered cameras approximately every 12 seconds.
Note
You cannot select this option if there is only one registered camera in the
parent unit.
If a baby (camera) unit is currently paired with the parent unit, * will appear
next to the camera number (*1 / 2 / 3 / 4).