8
Connecting the baby (camera) unit
You will need to carry out this process for the single or multi baby (camera)
units.
1. Plug the DC plug of the power adapter into the power socket on the rear of
the baby (camera) unit and plug the other end of the AC adapter into the
wall socket.
2. The baby unit turns on and the power indicator lights up in blue and blinks
in red after 30 seconds if the parent unit has not been powered up.
Connecting and charging the parent unit
A rechargeable battery is already pre-installed inside the parent unit. When
fully charged, you can move the parent unit without losing the link and picture
from the baby (camera) unit. When charging the battery for the first time,
charge for at least 16 hours continuously.
Important
Warning! Use only the approved rechargeable Lithium-ion battery supplied
with your PIP1510 CONNECT, PIP1510-2 CONNECT, PIP1510-3 CONNECT or
PIP1510-4 CONNECT.
Press and hold
1. Plug the DC plug of the power adapter into the power socket on the side
of the parent unit and plug the other end of the AC adapter into the wall
socket.
2. Switch on the AC power and the parent unit will turn on.
Getting started
To Next Page
Loading...
Need help?
General
