27
Programming Features
RDX
0 = Off (VOX with accessories only, default settings)
1 = Low sensitivity
2 = Medium sensitivity
3 = High sensitivity
Monitoring a Channel
Check for channel activity.
1. Press and hold
Q
. You will hear static if the channel is clear.
2. Press side button 1 icon again to release.
Programming Features
You can change the following features by entering the programming mode. To talk
with someone on your two-way radios, these settings must match:
• Channel
• Frequency
• Interference Eliminator Code
• Bandwidth (for optimal clarity)
You can also use the programming mode to set the following:
• Call tones
• Microphone Gain
Note: You cannot enter programming mode while a VOX accessory is plugged into
the radio.
6864110R04b.book Page 27 Friday, October 20, 2006 4:38 PM
To Next Page
Loading...
