Programming Features
32
RDX
Using the Multi-Unit Charger (RLN6309)
1. Enter programming mode on the programmed radio (M + SB1 + ON)
2. Place the programmed radio in one of the front pockets of the multi unit charger.
3. Turn the non-programmed radio ON and place it directly behind the programed
radio.
4. Press and hold PTT on the programmed radio until the non-programmed radio
beeps.
5. Turn the non-programmed radio OFF and back ON again to test cloning occurred.
6. Exit programming mode on the programmed radio.
Note: You can clone only one radio at a time.
The MUC does not need to be plugged in for Cloning feature to work.
Radios must be of the same band; UHF or VHF. Also, multi-channel models
can clone to single-channel radios, but only the first channel is cloned.
6864110R04b.book Page 32 Friday, October 20, 2006 4:38 PM
To Next Page
Loading...
