33
PROGRAMMING FEATURES
Reading CTCSS / DPL Values
Cycle through the features available for
configuration by short pressing the PTT button
until you hear the current code. The radio
moves to the programming CTCSS/PL codes
mode.
Enter a new code value using the SB1 and SB2
buttons.
The RVA Series radios have up to 219 codes
available. For more information, refer to
“Frequency and Code Charts” on page 54.
Reading Auto-Scan Values
After hearing the CTCSS/DPL codes, short
pressing the PTT button moves you to Auto-
Scan mode.
Auto-Scan has only two values:
• Enabled
• Disabled
Bandwidth
While in Auto-Scan mode, short pressing the
PTT button shifts the radio to ‘Bandwidth’
feature.
Change Bandwidth using the SB1 and SB2
buttons.
Active Channels
While in Bandwidth mode, short pressing the
PTT button shifts the radio to ‘Active Channels’
feature.
Modify the amount of channels available using
the SB1 and SB2 buttons.
Saving Settings
Once you are satisfied with the settings, you
can either:
• short press the PTT button to continue
programming,
• long press the PTT button to save and return to
‘Idle’ Programming Mode, or
• long press the PTT button twice to exit ‘Idle’
To Next Page
Loading...
