37
PROGRAMMING FEATURES
Example of Programming Auto-Scan
Auto-Scan is the third available feature in the
Programming Mode and can be set to either
ON or OFF on a particular channel.
To set Auto-Scan to ON:
• Enter Advanced Configuration Mode and select
the desired channel.
• Short press the PTT button three times to enter
the Auto-Scan Programming Mode. The audible
voice in the radio announces “Auto-Scan” and the
setting (Enabled or Disabled).
• To change the setting, press SB1 or SB2.
• Long press the PTT button. LED Indicator shows
a green heartbeat to indicate ‘Idle’ Programming
Mode.
• Long press the PTT button again to exit
Programming Mode or turn OFF the radio.
Example of Programming Bandwidth
Bandwidth is the fourth Programming Mode. It
allows you to modify the bandwidth assigned to
a channel.
To set Bandwidth:
• Enter Advanced Configuration Mode and select
the desired channel.
• Short press the PTT button four times to enter the
Bandwidth Programming Mode. The audible
voice in the radio announces “Bandwidth” and the
current value.
• Short press the SB1 or SB2 button until you get
the bandwidth desired for this channel.
• Long press the PTT button. LED Indicator shows
a green heartbeart to indicate ‘Idle’ Programming
Mode.
• Long press the PTT button to exit Programming
Mode or turn OFF the radio.
To Next Page
Loading...
