10 Getting Started
2. During power ON, when adapter is plugged in, the battery icon on
screen's top right corner will show that the battery is charging. Th
e
Blue
LED at the top left corner light up indicates adapter is plugged in.
2.4 Registration (Pairing)
The digital video pet monitor is pre-registered to your Owner Unit. You do not
need to register it again unless the Pet Unit loses its link with the Owner Unit.
To re-register your Pet Unit, or register a new Pet Unit, follow the
procedure below:
1. Press the
M button of the
owner
unit and the menu bar will pop up.
2. Press the
< LEFT button or > RIGHT button until is highlighted,
and the
/
/ / menu will pop up.
3. Press the
+ UP button or - DOWN button to select , and press
the OK b
utton to confir
m.
4. 1 /
2 / 3 / 4 will pop up, press the
+ UP button or -
DOWN button to select the desired CAM and press the OK button to
start searching for a pet unit. The green audio level LED
will flash
r
apidly wh
ile searching.
5. Pre
ss the OK button to confirm.
6. Press and hold the PAIR button underneath the pet unit until the
owner
unit finds the camer
a, beeps and the video from the camera appears.
NOTE
If a particular Pet Unit was registered previously, registering this current
Pet Unit again will overwrite the previous registration.
2.5 View Video Through TV
Connect a suitable AV cable into the AV OUT socket on the side of the
Owner
Unit and into the AV input of the TV. Scroll through the AV inputs
on the TV menu until the digital video pet monitor picture is shown.
AV cable is an optional accessory, available for purchase separately.
NOTE
The Monitor's power button must be turned ON and CAM pre-selected
before connecting the AV cable. Once the AV cable is connected, the
Monitor's controls cannot be activated.
To Next Page
Loading...
Need help?
General
