2. Getting Started
2.1
Pet
Unit Power Supply
1. Connect the small plug of the power adapter to the pet unit and the
other end to the electrical outlet.
NOTE
Only use the enclosed power adapter (5.9V DC / 1000mA).
2. Slide the ON/OFF switch to the ON position. The powe
r LED will
light up in green.
3. Slide the ON/OFF switch to the OFF position to turn the Pet Unit off.
2.2 Owner Unit Battery Installation
1. Insert the wire tab of the rechargeable battery pack into the contact
slo
t as shown above and fit the battery pack into the compartment.
2. Replace the battery cover over the compartment and gently tighten
the screw in a clockwise direction using a Small cross head or Fl
at
end scre
w drivers.
To Next Page
Loading...
Need help?
General
