System Administration
Motorola, Inc. 570510-001-00 rev A Page 24 of 50
V
V
i
i
e
e
w
w
S
S
y
y
s
s
t
t
e
e
m
m
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
a
a
n
n
d
d
S
S
t
t
a
a
t
t
u
u
s
s
Configuration and Status can be viewed using the Show commands. To view the available show items, use the
following command from the CLI:
show ?
Ex: View Current and alternate software versions on the system and the WallPlates:
show system image
show system inventory
show remote image
show remote inventory
T3 OS displays the configuration from the CLI in three useful modes. All configuration displays can be accessed
from the “show system config” command syntax.
Summary
Use the command: show system config summary
This command displays the configuration in an organized summary of each configured feature.
Use this output to quickly view the active configuration.
Startup
Use the command: show system config startup
Displays only the commands entered by the administrator that result in a configuration change
AND have been saved to memory. Use this command to capture an active configuration and
create a template for configuring other XLT switches.
Running
Use the command: show system config running
Displays only the commands entered by the administrator that result in a configuration change.
The changes may or may not have been saved to memory. Use this command to capture an
active configuration and create a template for configuring other switches.
Note: When the commit mode is set to manual, the Running config will be different from the
Startup config until the changes are committed.
To Next Page
Loading...
Need help?
General
