T5000 & T5500 user guide --- Pg 21
21
Alerts
T5000 & T5500 user guide --- Pg 22
22
Alerts
To transmit to a radio that has QT noise filtering turned on:
Select the same channel and Interference Eliminator Code as the other radio.
Press to send a call tone. This allows your voice to pass through the QT noise
filter on the receiving radio.
Press and speak normally.
1.
2.
3.
Note: If you skip step 2, the beginning of your message may not be heard on the
receiving radio.
For a 30-second period, starting after the last transmission, all transmissions
received on the selected channel and code will pass through the QT noise filter.
Transmitting a Talk Confirmation Tone
You can set your radio to transmit an unique tone when you finish transmitting. It's
like saying Roger or Over to let others know you are finished talking.
To turn talk confirmation on, press and hold while you turn the radio on. When
you release after transmitting, your call tone transmits and displays.
To turn talk confirmation off, turn your radio off and then back on while pressing
and holding .
•
•
QT Noise Filtering
The QT noise filtering feature helps ensure uninterrupted communication with other
Motorola radios that have this feature. This feature filters out unwanted transmissions
from other radios. It is useful in places where there is heavy radio traffic, such as at
an amusement park or ski resort.
Note: QT noise filtering is not available while the radio is scanning.
To turn QT noise filtering on or off:
Press until displays.
Press or until displays to turn noise filtering on, or until – displays to
turn noise filtering off.
Press to confirm your selection.
1.
2.
3.
To Next Page
Loading...
Need help?
General
