Special Features
Special Features
Interference Eliminator Codes
Interference Eliminator Codes help minimize interference by providing a choice of
code combinations. Your radio has 99 Interference Elimintor Codes. Codes 1-38 are
the standard codes that appear on other FRS/GMRS radios. Codes 39-99 are
additional digital codes added for superior interference protection.
To set the code for a channel:
1. Press until the code starts to flash.
2. Press or to select the code.
3. Press to save the code setting.
You can set a different code for each channel using this procedure. An extended
press of or allow you to scroll through the Interference Eliminator Codes
rapidly so you can quickly reach the code you want.
Note: You must set the Interference Eliminator Code to on a radio that uses
Interference Eliminator Codes to communicate with radios that do not have
Interference Eliminator Codes.
Push to Talk Timeout Timer
To prevent accidental transmissions and save battery life, the radio emits a
continuous warning tone and stops transmitting if you press for 60 continuous
seconds.
19
To Next Page
Loading...
