16
English
Internal Voice Operated Transmission/
Voice Operated Transmission ( / )
Transmission is initiated by speaking into the
microphone of the radio/audio accessory instead of
pushing the PTT button.
1. Press Menu until the icon appears on the
display. When audio accessory is connected, the
icon is shown. The current setting (Off, L1–L3) flashes.
2. Press or to select the sensitivity level.
3. Press the PTT button to exit menu or Menu to
continue set up.
Note:
When using iVOX/VOX, there will be a short
delay.
Dual Watch Mode
Enables you to scan the current channel and
another channel alternately.
To set another channel and start Dual Watch.
1. Press Menu/Lock until appears. The
flashes.
2. Press or to select the channel, then press .
3. Press or to select the code.
4. Press the PTT button or wait until the time out to activate
Dual Watch. The screen alternates between Home
Channel and Dual Watch Channel.
5. To end Dual Watch mode, Press icon.
Note:
If you set the same channel and code as
current channel, Dual Watch does not work.
Keypad Tones
You may enable or disable the speaker key tones.
You hear the key tone each time a button is pushed.
1. Press Menu/Lock button until appears. The
current setting On/Off flashes.
2. Press either or to turn On or Off.
3. Press the PTT button to confirm and exit Menu or
Menu/Lock button to continue set up.
Note:
When the keypad tone feature is off, the
following are not disabled:
• Transmit timeout alert tone
• Call tone
• Low battery alert tone or
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most
environments
L1 = Low Sensitivity for noisy environments
01_MN006555A01_en-US.fm Page 16 Friday, July 10, 2020 1:17 PM
To Next Page
Loading...
Need help?
General
