Chapter 2
Getting Started
This chapter provides instructions on how to prepare your radio for use.
2.1
Installing and Charging the Battery
Prerequisites: Observe the polarity before installing the battery.
Figure 3: Battery Polarity
Procedure:
1 To charge the battery, use the desktop charger or USB.
When the battery is charging, the battery icon on the radio blinks and stops blinking when the
battery is full.
NOTE:
• Connect the USB charger to a nearby and easily accessible wall power outlet. Turn
off the radio before charging.
• An empty battery will be fully charged in 8 hr.
CAUTION: Use only Motorola Solutions approved batteries. There is a risk of explosion if
the battery is replaced by an incorrect type.
2.2
Attaching the Belt Clips
Procedure:
1 Attach the belt clip to the belt clip slot at the back of the radio until the clip clicks in place.
MN009248A01-AA
Getting Started
11
To Next Page
Loading...
