17Using the phone
IMPORTANT
When the phone is ringing, avoid holding the earpiece too close to your ear as it may
damage your hearing.
NOTE
If auto pick up mode (see page 34) is on, simply lift up the handset from its base to
answer the call. The default setting is O. See all “Default settings” on page 40.
An incoming call has priority over other events. Whenever there is an incoming call, other
operations in progress such as phone settings, menu navigation, etc. will be ended.
3.7 Adjust volume
1. During a call, press u or d to adjust the earpiece or hands-free volume. The level is
shown in the handset display.
3.8 Mute
Mute the microphone so that you can talk to someone else in the room without your caller
hearing you.
1. During a call, press b. The microphone is muted.
2. Press b again to turn the microphone back on.
3.9 End a call
1. Press e.
After you hang up, the duration the phone is o-hook is displayed for 2 seconds.
NOTE
If auto hang-up is o (see page 34) you must press e to end the call. The default setting
is
On
.
3.10 Switch handset on/o
1. Press and hold e to switch the handset on or o.
3.11 Intercom
This feature is only available when there are at least 2 registered handsets. It allows you
to make internal calls, transfer external calls from one handset to another and use the
conference option.
3.11.1 Call another handset
1. Press and hold *.
• If you have two handsets, the other handset is called automatically.
• If more than two handsets are registered to the base, the rst handset number is
displayed. Scroll d the number of the handset you want to call and press M or
press * to ring all handsets.
2. Press e to hang up.
To Next Page
Loading...
Need help?
General
