9Getting started
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for all the
handsets and chargers.
1. Plug the power adaptor into the socket marked on the underside of the charger
and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the 2 x AAA Ni-MH
rechargeable batteries supplied. Please note the ’+’ and ’-’ markings inside the battery
compartment and insert in the correct direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the rst time, place the handset on the charger to
charge for at least 16 hours continuously. When the handset is fully charged, the S
icon will appear steady on the display.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH 550mA
rechargeable batteries) supplied with your TD1. Do not use alkaline or non rechargeable
batteries. It may cause permanent damage to the product and void the warranty.
BATTERY LOW WARNING
If you hear a warning beep every 2 minutes during a call, you will need to recharge the
handset before you can use it again.
When charging, the S icon will scroll on the display. Once charged scrolling will stop.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 14 hours talk time or up to 220
hours standby time on a single charge.
1
Note that new batteries do not reach their full capacity until they have been put to normal
use for several days.
To Next Page
Loading...
Need help?
General
