Ajay16 Motorola v3 Disassembly Guide v1.1
Page: 28
Compiled Exclusively for MotoModders.net
Keypad Fix:
My keypad had a few keys that didn’t work properly. If you pressed
on the right hand side just below the battery door the keys worked.
These keys were: Down, Left Softkey, *, 8. If you cut a small piece of
plastic phone card then half it right down the side so its half the
thickness, and place it under the connector it fixes it.
What to do if you don’t have the plastic frame on your facia, or the
battery lock on your battery door:
Take your old facia, slide a knife under the thinnest part of the plastic
frame, you have to use A LOT of pressure. BE VERY CAREFUL!
(When I was doing this on my silver v3 I slipped with the knife and
sliced my finger to the bone!) Work your way all round the plastic
frame.
Clean off the glue attached to the frame. With your knife or a sharp
craft knife scrape #ing all over were the frame sits. Then use
something like Araldite, or super strong bonding adhesive, not just
modeling glue. Put some of the bonding agent on the frame and the
To Next Page
Loading...
Need help?
General
Weight and Dimensions
