Ajay16 Motorola v3 Disassembly Guide v1.1
Page: 29
Compiled Exclusively for MotoModders.net
metal housing. Only a little bit all round. Push the frame and the facia
onto your v3, MAKE SURE THERES NO EXCESS before you do
this. Then put elastic bands round the body of your v3. two across the
body and one longways. Do these as tight as you can!
Every hour or so press all of the outer buttons as some excess will
most likely be trying to stick them. Leave for 24 hours at least.
Battery Cover:
Slide the knife under the battery lock, prise it up. BE VERY
CAREFUL!
Then scrape off the old glue. Clean off the glue attached to the frame.
With your knife or a sharp craft knife scrape #ing all over were the
frame sits. Then use something like Araldite, or super strong bonding
adhesive, not just modeling glue. Put some on the battery lock and
the battery door. Push down, then wipe away any excess. Leave for
24 hours.