13
Display icons
Indicates the current signal strength level (4 levels).
Indicates the night vision mode is on. The video turns black and white.
Indicates the screen o time is set.
Volume level setting (8 levels) is in progress.
Unable to detect the baby (camera) unit.
Indicates the current battery level (4 levels).
Note
Depending on the video settings, the display will go blank after 5 minutes, 15
minutes, or 30 minutes to save power.
Registering the baby (camera) unit to the parent unit
(Pairing)
The video baby monitor is pre-registered to your parent unit. You do not need
to register it again unless the baby (camera) unit loses its link with the parent
unit.
To re-register your baby (camera) unit, see the following steps.
1. Tap on the menu bar.
2. Tap and / / / will pop up.
3. Tap / / / to select a desired camera. The parent unit starts
searching the baby (camera) unit.
Note
A baby (camera) unit can be paired only to one parent unit each time. If a baby
(camera) unit is currently paired with the parent unit, it will appear in dark grey
on the screen and cannot be selected for a new registration.
4. Press and hold
PAIR
on the underside of the baby (camera) unit until the
parent unit finds the baby (camera) unit and
Pair OK
appears on the screen.
The video from the baby (camera) unit will then appear.
Getting to know your baby monitor
To Next Page
Loading...
