QUICKSTART GUIDE | VT100 14
You can change the vertical angle of your VT100 by adjusting the stud on the back of your device to point up or
down.
To detach a VT100 from the epaulette clip, pull the metal clip on the back of the stud towards the mount, and
slide the stud (with the epaulette clip) upwards out of the attachment rail.
To detach an epaulette mount from your uniform, slide the mount upwards slightly so the hook detaches from
your epaulette’s button. Open the clip and rotate the mount by 90 degrees while pulling down on it. This should
help the mount to slide out easily.
This can also be used to attach a VT100 to a radio loop or rucksack loop, following the same instructions.
To Next Page
Loading...
Need help?
General
