Advanced Features
English
42
Sending a Quick Text Message
Your radio supports a maximum of ten (10) Quick Text
messages as programmed by your dealer.
While Quick Text messages are predefined, you can edit each
message before sending it.
Procedure:
Press the programmed Text Message button and proceed to
step 3.
OR
Follow the procedure below.
1 S to access the menu.
2 Por Q to Messages and press N to select.
3 Por Q to Quick Text and press N to select.
4 Por Q to the required Quick Text and press N to
select.
5 A blinking cursor appears.
Use the keypad to edit the message, if required.
Press
P to move one space to the left.
Press
Q or the # key to move one space to the right.
Press the *DEL key to delete any unwanted characters.
6 Press N once message is composed.
7 Por Q to the required alias or ID and press N to
select.
OR
Por Q to Manual Dial and press N to select.
Key in the subscriber alias or ID and press N.
8 The display shows Text Message: <Subscriber/Group
Alias or ID>, confirming your message is being sent.
9 If the message is sent successfully, a tone sounds and the
display shows Message Sent.
OR
If the message cannot be sent, a low tone sounds the
display shows Message Send Failed.
If the message fails to send, the radio returns you to the
Resend
option screen (see Managing Fail-to-Send Text Messages on
page 43).
Sending a Quick Text Message with the One Touch
Call Button
Procedure:
1 Press the programmed One Touch Call button to send a
predefined Quick Text message to a predefined alias or ID.
NAG-LACR-EMEA.book Page 42 Monday, April 28, 2008 4:59 PM
To Next Page
Loading...
