3 Perform one of the following:
• To break-in successfully, press on the PTT button
of the radio with WAIT on the display within 3
seconds, radio will display COMPLETE!.
• To break-in successfully, press on the PTT button
of the radio with BREAK on the display within 3
seconds, radio with WAIT display will turn to
COMPLETE!.
• To break-in unsuccessfully, do not press on any
PTT button on any radio, wait for the break-in
limited period to expire, radio with WAIT display
will show FAIL!.
The duration of the break-in limited period can be
programmed through CPS.
4 The other users whose transmission were broke-in
have to wait for the TOT to expire before performing
any transmission.
4.12
Radio ID Direct Call
Direct call is a feature that enables radio to transmit call
using the Radio ID. The following steps explain how to
make direct call using radio ID:
1
At Home screen, press .
2 Use the Alphanumeric keypad to enter the Radio
ID.
3 Press on the PTT button to make a call.
4.13
Reverse Burst
NOTICE:
This feature is only available in Analogue Mode.
Reverse Burst eliminates unwanted noise (squelch tail)
during loss of carrier detection. User is allow to select the
value of the Reverse burst with the setting range of Off/
120/180/240. The default value of Reverse Burst is 240.
• Some of the features available with the CPS software
may vary depending on the radio model.
English
Send Feedback 57
To Next Page
Loading...
