English
8
Scan
The scan facility allows you to easily scan all 8
channels. When an active channel is detected, the
radio pauses on that channel until the channel is clear.
After a 2 second delay, the radio will continue scanning.
1.To select the scanning function, press and hold
CH/SCAN until SCAN
is displayed. The radio will
scroll through the channels.
2.If you activate scan while your code is set to
00, then
the radio will check for any activity on each channel,
regardless of the code in use on that channel.
3.If you activate scan while the code is set on
01 to 38, the radio will only check for activity on the
specific channel and code combinations that are set
on your radio.
4.When activity is detected on a channel, the radio will
stop scanning and you will hear whatever transmis-
sions are detected. The radio’s display will show the
channel and code on which activity was detected.
5.If you want to respond to the transmission, press
PTT while the scan is paused on that channel.
6.To stop scanning, press
SEL/ , ^ or press and
hold CH/SCAN for 2 seconds.
Priority Channel Scan Feature
Your radio has a priority channel scan feature that
allows you to scan between current channel and
priority channel. When an active channel is detected,
the radio will pause on that channel until the channel is
clear. Then after a 2 second pause, the radio will
continue scanning. Pressing PTT while the scan is
paused on a channel will allow you to transmit on that
channel.
To select the priority channel:
1.Press PRI/ROOM. The PRI icon is displayed and the
priority channel will flash.
2.Use the VOL/CH side button (+) or (-) to increase or
decrease the priority channel number displayed.
3.Press
SEL/ . The priority channel code will flash.
4.Use the VOL/CH side button (+) or (-) to increase or
decrease the code number displayed.
5.To start the priority channel scan, press
SEL/ .
6.To exit the priority channel scan press PRI/ROOM.
Hands Free Use (VOX)
VOX allows you to talk “hands free” from the radio or
when used with optional accessories connected to the
radio.
Note: When using audio accessories with your radio,
turn the volume of your radio down before you
place the accessory on your head or in your ear.
To use the VOX feature:
1.Press and hold
SEL/ to switch off your radio.
2.Open the accessory cover and insert the audio
accessory into the accessory jack.
3.Press and hold
SEL/ to switch on your radio.
4.Press
SEL/ until the VOX icon is displayed. The
current level (
oF,1-3) will also flash. Selecting oF
(OFF) disables VOX.
6864234V01-A_EN Final2.fm Page 8 Monday, August 14, 2006 3:38 PM
To Next Page
Loading...
