2 Safety Instructions
10 Rev. 12/2019
Risk of injury!
To avoid injury, make sure that you do not trip over the cables of the
SparkScan1 high voltage clamp or the BNC cable when using the SparkView
high voltage indicator.
Risk of destruction!
Excess voltage may destroy or damage the SparkView high voltage indica-
tor. Stop the measurement immediately if continuously values above 25 kV
(set measuring range up to 25 kV) or above 50 kV (set measuring range up
to 50 kV) are measured.
Risk of destruction! Operational safety!
Third-party products can destroy the SparkView high voltage indicator and
lead to incorrect measurement results. Operate the SparkView solely with
the MOTORTECH SparkScan1 high voltage clamp, with high-quality
MOTORTECH BNC cables and with MOTORTECH ignition coils featuring a
BNC diagnostic interface.
Risk of destruction!
When the battery compartment is open, moisture and dirt may get into the
SparkView high voltage indicator and destroy it. You should therefore only
use the device with the battery compartment cover firmly screwed shut.
Risk of damage!
Hot engine parts can damage the grounding cable of the SparkScan1 high
voltage clamp, the BNC cable or the SparkView high voltage indicator. Avoid
contact of the products with hot spots. Do not use damaged products.
Danger of radio communication interference!
This equipment is not intended for use in residential environments and may
not provide adequate protection to radio communication services in such
environments.
To Next Page
Loading...