71
EN
BEFORE FIRST USE
USER’S MANUAL
Packaging removal
• Remove the multicooker from the packaging. Save the guarantee card, and before rst use,
be sure to read the multicooker instruction manual.
• Place the multicooker on a at surface. Remove everything inside the multicooker: plastic
bags, accessories (stand, rice spoon, measuring cup, and drip tray) and power cord.
• Before rst use, remove the advertising sticker from the multicooker housing assembly.
• Warning : Washing the cooking pot in the dishwasher is forbidden (this part is not dishwasher
safe).
Opening the lid
• To remove the lid, grasp the handle, turn it anticlockwise and lift -g. 1-2.
Cleaning
• Rinse the Cooking pot, lid, condensation collector, trivet, and lid gasket with water.
First use of the multicooker
• Unwind the power cord, plug it into the corresponding socket on the multicooker housing,
and then plug it into a grounded outlet - g. 7.
Place the condensate tank in the location shown in g. 6.
Remove the pot and ll it with the required ingredients.
• Remove the cooking pot from the multicooker.
• Put the required ingredients in the cooking pot.
• Be careful - the level of products and liquids should not exceed the maximum mark on the
inside of the cooking pot -g. 8.
Place the pot in the multicooker
• Wipe the bottom of the cooking pot dry and remove food residue on the heating plate. Then
place the cooking pot with food in the multicooker, make sure that the cooking pot is placed
evenly -g. 9-10.
• Do not use the multicooker without the pot.
Close and lock the lid (for pressure cooking)
• Make sure that the lid gasket is securely located inside the lid.
• Place the lid on the multicooker - g.11 and holding the lid handle, turn it clockwise -g.
12. The position of the lid for various functions (open / closed, but not locked / closed and
locked) should correspond with table 1.
Install the pressure limit valve
• Position the pressure limit valve and take care that it clicks well into place.
To Next Page
Loading...
