Mountfield 1228M H User Manual

EN 17HOW TO USE THE MACHINE
5. HOW TO USE THE MACHINE
REMEMBER THAT THE USER IS ALWAYS RESPONSIBLE
FOR DAMAGE AND INJURIES TO OTHERS. Before using the machine,
read the safety requirements shown in chapter 2, paying particular atten-
tion to driving and cutting on slopes. It is the user's responsibility to
assess the potential risk of the area where work is to be carried out, as
well as to take all the necessary steps to ensure safe working, particularly
on slopes or rough, slippery and unstable ground. This machine must not
be used on slopes greater than 10° (17%).
If the machine is likely to be used mostly on sloping
ground (max. 10°), fit counterweights (supplied on request) to the front
part of the frame to improve stability at the front and reduce the chance
of tipping up.
All references regarding the positions of controls are shown
in chapter 4.
5.1 DIRECTIONS BEFORE STARTING
S
EAT ADJUSTMENT
The seat is held by four screws (1) which
have to be loosened for changing the
position of the seat which is done by slid-
ing it along the slots in the base.
When you have got in a comfortable
position, fully tighten the four screws.
R
EFUELLING
The oil and fuel to use are indicated in the engine booklet.
To reach the oil level dipstick, lift up the seat and open the hatchway beneath.
NOTE
IMPORTANT

!
WARNING!

!
DANGER!
1
1

Mountfield 1228M H Specifications