EasyManuals Logo

Mountfield 1228M H User Manual

Mountfield 1228M H
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
EN 27HOW TO USE THE MACHINE
The circuit automatically resets after a few seconds but the cause of the fault
should be ascertained and dealt with to avoid re-activating the protection
device.
To avoid activating the protection device:
do not reverse the cables on the battery terminals;
do not use the machine without its battery or damage may be caused to the
charging regulator;
be careful to not cause short-circuits.
E
ND OF MOWING
When you have finished mowing, disengage
the blade and ride the machine with the cut-
ting deck in the highest position.
Stop the machine, engage the parking brake
and turn off the engine by turning the ignition
key to «OFF».
When the engine is stopped, close the fuel
cock (1) (where fitted).
To avoid backfire, put the accelerator in the «SLOW»
position for 20 seconds before stopping the engine.
Always take out the ignition key if leaving the machine
unattended!
To keep the battery charged, do not leave the key in the
«ON» position when the engine is not running.
5.4 CLEANING AND STORAGE
C
LEANING
After each mowing, clean the outside of the machine, empty the grass-catcher
and shake it to remove residual grass and earth.
Clean the plastic parts of the body with a damp sponge using water and deter-
gent, taking care not to wet the engine, the electrical parts or the electronic card
located under the dashboard.
Never use hose-nozzles or harsh detergents for cleaning the
body and engine!
IMPORTANT
IMPORTANT
!
WARNING!
!
WARNING!
IMPORTANT
1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mountfield 1228M H and is the answer not in the manual?

Mountfield 1228M H Specifications

Mechanical Drive Model

Speed IconSpeed
forward speed in 1st gear1.5 km/h
forward speed in 2nd gear2.7 km/h
forward speed in 3rd gear4.0 km/h
forward speed in 4th gear4.5 km/h
forward speed in 5th gear6.8 km/h
reverse speed2.0 km/h
Weight and Dimensions IconWeight and Dimensions
weight159 ÷ 168 kg
inside turning circle1.4 m

Hydrostatic Drive Model

Cutting Specifications IconCutting Specifications
cutting height3 ÷ 8 cm
cutting width71 cm
grass-catcher capacity170 liters
Speed IconSpeed
forward speed0 ÷ 8.6 km/h
reverse speed0 ÷ 3.2 km/h

1228M H

Power and Electrical IconPower and Electrical
electrical system voltage12 V
battery capacity18 Ah
Tyres IconTyres
front tyre size11 x 4-4
rear tyre size15 x 6-6
front tyre pressure1.5 bar
rear tyre pressure1.0 bar

Related product manuals