Mountfield 1228M H User Manual

switches off.
– 25 A fuse = protects the battery charger circuit. When it blows, the battery
gradually runs out and the machine will have problems starting.
The fuse capacity is indicated on the fuse.
A blown fuse must always be replaced by one of the same
type and ampere rating, and never one of a different rating.
If you cannot find the cause of the protection device's activation, consult a
Licensed Service Centre.
C
HANGING WHEELS
Stop the machine on a flat surface and
put blocks under a load-bearing part of
the frame on the side that the wheel is to
be changed.
The wheels are held by a snap ring (1)
which can be taken off with a screwdriv-
er.
The rear wheels are directly coupled to
the axle shafts and fastened by a key that
forms part of the wheel's hub.
Before re-fitting a wheel, smear some grease on the axle and carefully re-fit the
snap ring and washer (2).
Should you substitute one or both rear wheels, ensure that
they are of the same diameter, and check that cutting deck is horizontal to pre-
vent an uneven cut.
C
HANGING AND REPAIRING TYRES
Tyres are of the «Tubeless» type and therefore all puncture repairs will have to be
carried out by a tyre-repair expert in accordance with the methods for this kind
of tyres.
NOTE
IMPORTANT
EN 32 MAINTENANCE
2 1

Mountfield 1228M H Specifications