EN
• Immediately clean up all traces of fuel spilt on the machine
or on the ground.
•
• Never start the machine in the same place in which you
•
2.3 DURING OPERATION
Work Area
•
dangerous carbon monoxide fumes can collect. The start-
up operations must be carried out outdoors or in a well-
ventilated area. Always remember that the exhaust gases
are toxic.
•
•
tools create sparks which may ignite the dust or fumes.
•
visibility conditions.
•
area. Children must be supervised by another adult.
•
•
•
machine could overturn if a wheel slides over the edge or if
the earth gives way.
•
machine to slide sideways or make you lose control of it.
•
•
material.
Behaviour
• Exercise caution when reversing or moving backwards.
Look behind you to make sure there are no obstacles
before and during use whilst in reverse gear.
•
•
•
when starting and using the machine.
• Attention: the cutting blade will continue to rotate for a few
seconds after disengagement or after you have switched
• Keep away from the discharge opening.
•
If something breaks or an accident occurs whilst
mowing, turn o the engine immediately and move the
machine away to prevent further damage; if an accident
occurs with injuries or third parties are injured, carry
out the rst aid measures most suitable for the situation
immediately and contact the medical authorities for
any necessary health care. Carefully remove any debris
which could cause damage or injury to persons or
animals if ignored.
Use limitations
•
•
installed in their seats.
•
•
the maximum rpm. If the engine is forced to run at an
•
improve the quality of your work.
2.4 MAINTENANCE, STORAGE AND TRANSPORT
Ensure regular maintenance and correct storage to
maintain machine safety and high performance levels.
Maintenance
• Never use the machine with worn or damaged parts.
never repaired.
•
a regular basis.
•
The noise and vibration levels shown in these
instructions are the maximum levels for use of the
machine. The use of an unbalanced cutting blade,
the excessive speed of movement, or the absence of
maintenance have a signicant inuence on noise
emissions and vibrations. Consequently, it is necessary
to take preventive steps to eliminate possible damage
due to high levels of noise and stress from vibration;
Maintain the machine well, wear ear protection devices,
and take breaks whilst working.
Storage
•
a strong heat source.
•
inside a room.
2.5 ENVIRONMENTAL PROTECTION
Safeguarding the environment must be a relevant and
and the environment we live in.
•
machine at reasonable times of the day only (not early
morning or late evening when the noise could cause
disturbance).
• Comply with local regulations for the disposal of
materials.
• Comply with local regulations for the disposal of waste
materials.
•
disposal facility in accordance with the local regulations
in force.
To Next Page
Loading...
Need help?
General
