EN
4.1 UNPACKING
1.
2. Take out the machine and dispose of the box and
packaging in compliance with local regulations.
4.2 HANDLE ASSEMBLY
4.3 GRASS CATCHER ASSEMBLY
5. CONTROLS
5.1 MANUAL START HANDGRIP
5.2 PUSH-BUTTON ELECTRIC START
5.3 ENGINE BRAKE LEVER / CUTTING BLADE
5.4 DRIVE LEVER
IMPORTANT The engine must be started only with
the drive OFF.
IMPORTANT Avoid moving the machine backwards
when the drive is ON.
5.5 CUTTING HEIGHT ADJUSTMENT
Do this when the cutting blade is stationary.
• Adjustment (
6. USING THE MACHINE
IMPORTANT For instructions on the engine and the
battery (if applicable), refer to the corresponding manuals.
6.1 PRELIMINARY PROCEDURES
ground.
6.1.1 Filling with oil and fuel
IMPORTANT The machine is supplied without engine oil
and without fuel.
6.1.2 Preparing the machine before starting work
NOTE This machine can be used to mow lawns in
various ways;
a. Preparation for grass cutting and collection in
the grass catcher:
1.
I.
b. Preparation for grass cutting and rear grass
discharge on the ground:
1.
c. Preparation for grass mowing and chopping
(mulching function):
d. Preparation for grass cutting and side
discharge on the ground:
1.
it clicks into place.
To remove the side discharge chute:
6.1.3 Handle incline adjustment
Do this when the cutting blade is stationary.
6.2 SAFETY CHECKS
Always carry out the safety checks before use.
6.2.1 Safety check before every use
• Check the integrity and the correct mounting
•
• Keep all surfaces of the machine clean and dry.
6.2.2 Machine operating test
Action Result
1. Start the machine
2.
blade.
1. The cutting blade
should move.
2. The levers should
return automatically
and rapidly to the
and the cutting blade
must stop within a few
seconds.
To Next Page
Loading...
Need help?
General
