Mountfield SP53H - Problem Identification

EN
10. MAINTENANCE TABLE
Intervention Frequency Notes
MACHINE
Check all fasteners

blade.
Before use 
General cleaning and inspection

After each use 
 - 
ENGINE
 Before use 


* *


11. PROBLEM IDENTIFICATION


PROBLEM PROBABLE CAUSE SOLUTION
1. The engine

does not

operates
irregularly or
stops during
operation
Incorrect starting procedure 
No oil or fuel in the engine. 

gap.
Check the spark plug (refer to the engine manual).
 
Carburation fault. 



2. Engine

The manual start handgrip has been
operated repeatedly with the starter
engaged.

The manual start handgrip has been
operated repeatedly with the spark plug
cap removed.
Insert the spark plug cap and try to start the engine.

3. The cut grass
is no longer
collected in
the grass
catcher.
The cutting blade has hit a foreign

Stop the engine and remove the spark plug cap. Check for any


The inner part of the chassis is clogged. 
4. Mowing is

The cutting blade is not in good
condition

sharpening or replacement of the cutting blade.
5. Excessive

or vibration is
experienced
whilst
working.

The pin on the cutting blade is out of
its seat.

Check for any damaged or loose parts.



cutting blade is damaged.

