What to do if there is a failure of air pressure in my Mountz HD?
If you are experiencing a failure of air pressure with your Mountz Power Screwdriver, first, turn off the power and check the air inlet outside. If the error persists after pressing the RESET button, check the air lines through the connector, cable, and actuator clutch.
How to prevent overheat of motor in Mountz HD Power Screwdriver?
If your Mountz Power Screwdriver motor overheats, one solution is to use intermittent operation, such as 1 second ON followed by 3 seconds OFF.
What to do if my Mountz HD has communication failure over 1 sec?
If your Mountz Power Screwdriver experiences a communication failure lasting over 1 second, check the cable connection between the driver and the controller.
General| Type | Pneumatic |
|---|---|
| Air Inlet (NPT) | 1/4" |
| Handle Type | Pistol |
| Start Type | Push-to-Start |
| Power Supply | Pneumatic |
| Chuck Type | 1/4" |
To Next Page
