What to do if there is a failure of air pressure in my Mountz Power Screwdriver?
If you are experiencing a failure of air pressure with your Mountz Power Screwdriver, first, turn off the power and check the air inlet outside. If the error persists after pressing the RESET button, check the air lines through the connector, cable, and actuator clutch.
How to prevent overheat of motor in Mountz Power Screwdriver?
If your Mountz Power Screwdriver motor overheats, one solution is to use intermittent operation, such as 1 second ON followed by 3 seconds OFF.
What to do if my Mountz HDC-40i Power Screwdriver has communication failure over 1 sec?
If your Mountz Power Screwdriver experiences a communication failure lasting over 1 second, check the cable connection between the driver and the controller.
What to do if there is over current on AMP board circuit in Mountz HDC-40i Power Screwdriver?
If you encounter an over current on the AMP board circuit with your Mountz Power Screwdriver, check for any mechanical load failures and inspect the motor quality.
What to do if my Mountz HDC-40i shows a Hall sensor error?
If you are experiencing a Hall sensor error with your Mountz Power Screwdriver, check the cable quality and connectors. Also, inspect the wiring inside the driver.
What to do if I get a driver data error on my Mountz HDC-40i Power Screwdriver?
If you are getting a driver data error with your Mountz Power Screwdriver, ensure that the controller power is off when the driver is connected to the controller.
What to do if my Mountz HDC-40i has an initial communication failure?
If your Mountz Power Screwdriver experiences an initial communication failure, retry powering on the device after turning it off.
What happens in case of over time of Motor Lock in Mountz Power Screwdriver?
To prevent the motor from overheating, the Mountz Power Screwdriver will stop immediately after 1 second from the motor lock.
Outlines the electrical and air pressure specifications for the HDC controller.
Describes the controller's front panel display, buttons, and connectors.
Guides on setting torque, speed, and angle using the PC program, Hi-Manager.
Explains how to set torque, speed, and angle directly via the controller's front panel.
Lists system-related error codes, their descriptions, and methods for resetting them.
Guides on setting various parameters like fastening, controller, and screw count using the Hi-Manager interface.
General| Model | HDC-40i |
|---|---|
| Type | Power Screwdriver |
| Power Supply | Electric |
| Voltage | 24V |
| Brushless | Yes |
| Accuracy | ± 3% |
| Drive Size | 1/4" Hex |
| Speed (RPM) | 1000 |
To Next Page
